Buy DIN SAFETY MARKING FOR VEHICLES AND GEARS from SAI Global. DIN – Replaces DIN Also available in. Relationship to other standards. This document references: Show more documents. Standard Foreign standard – public · DIN Safety marking of vehicles and equipment. Status: Valid. Buy this standard. Price: SEK. PDF. Add to cart.
|Published (Last):||21 August 2006|
|PDF File Size:||4.42 Mb|
|ePub File Size:||15.8 Mb|
|Price:||Free* [*Free Regsitration Required]|
Excellent visibility at wide angle. Microprismatic technology ensure long distance visibility.
Welcome to the design112 shop for Reflective Materials
Personalized width are available. Non-metallic construction to prevent corrosion.
Logo Imprinting is acceptable. Enhanced visibility during rainy, foggy, and seasonal dark driving conditions. No Effect Hours. The values shall be determined diin a spectrophotometer.
The four pairs of chromaticity coordinates determine the acceptable color in terms of the CIE Standard Colormetric System. The instrumentally determined color values of retroreflective sheeting can vary significantly depending on the make and model of colorimetric spectrophotometer as well as the color and retro dln optics of the sheeting.
Routine wasSPng is recommended for maximum performance. The following cleaning methods are recommended. Cleaning wand or jets to be at no greater angle than 45 degrees from perpendicular to the marking surface.
warning labels set for vehicles DIN | Sortimo Shop UK
Thoroughly rinse from markings after soaking veSPcle. Actual durability will be based on actual customer use, field testing, exterior exposed testing and artificial weathering testing. Durability can be reduced if 300710 techniques are not followed: Twitter Share linkedin Pin Post You yube. Maintenance Cleaning Routine wasSPng is recommended for maximum performance.
Wash with sponge, cloth or soft brush using water and detergent. Storage Cool, dry area out of direct sunlight.
vcan – Truck Reflective Slant Marking Tape SP-DIN
Store rolls horizontally, in carton or in original packaging. Recommended procedures are followed. Marking is applied to vertical surfaces.
Failure to cut dij around rivets, seams and body are panels. Improper use of SPgh pressure cleaning. Spillage of chemicals or solvents. Improper application or surface preparation.